|
| Linear Guide Rail and Block Assemblies |
| |
 |
Flange with screw type linear guide rail and block assy |
| The roller linear guide assembly consists of guide, slide, steel ball, reverser, retainer, seal end and baffle etc. When the guide and slide act relative movement, the steel ball will roll along the four annealed precise ground raceways on the guide and enter into return hole through reversal unit (reverser) at the end of slide before entering into raceways, the steel ball rolls recurrently in this way. The two ends of reverser are equipped with dust-proof seal ends to prevent dust and detritus from entering into inner slide effectively... |
 |
Without flange with screw square type linear guide rail and block assy |
| The roller linear guide assembly is to place proper steel ball between slide and guide to make slide friction between slide and guide change into rolling with less static friction difference and good follow-up, that is the lagging interval between drive signal and mechanical action is very short, which is beneficial to improving response speed and sensitivity of NC system.... |
 |
Other linear guide and block assy |
| Linear motion guide assembly consists of rail、block、balls、retainer、recirculator、sealing gasket and side panel (see below) When the block moves in a linear direction relative to the rail, balls run along four raceway grooves which have been quenched and precisely finished. In the top of the block, balls again pass through the recirculator into reciprocating hole then into raceway repeatedly. ... |
|
 |
